Promise Technology FastTrak TX4650 User Manual page 102

FastTrak TX4650, TX2650 User Manual
Automatically After Drive Replacement
Automatic rebuilding after you replace the failed drive is possible under the
following conditions:
• The logical drive is a RAID 1, 5, or 10.
See "Creating a Logical Drive" on page 80.
• The replacement drive has adequate capacity.
• Automatic Rebuild Status is Enabled.
See "Making Controller Settings" on page 68.
WebPAM will report the automatic rebuild in its user interface, as well as via
popup messages, and via email, depending on your settings (see page 57).
Automatically using a Hot Spare Drive
Automatic rebuilding using a hot spare drive is possible under the following
conditions:
• The logical drive is a RAID 1 or a three-drive RAID 5.
See "Creating a Logical Drive" on page 80.
• You have a hot spare drive with adequate capacity.
See "Creating a Spare Drive" on page 107.
• Automatic Rebuild Status is Enabled.
See "Making Controller Settings" on page 68.
WebPAM will report the automatic rebuild in its user interface, as well as via
popup messages, and via email, depending on your settings (see page 57).
You can replace the failed physical drive at your convenience.
Automatically using a Free Drive
Automatic rebuilding using a free (unassigned) physical drive is possible under
the following conditions:
• The logical drive is a RAID 1 or a three-drive RAID 5.
See "Creating a Logical Drive" on page 80.
• There is a free (unassigned) physical drive with adequate capacity.
• Automatic Rebuild Status is Enabled.
See "Making Controller Settings" on page 68.
• Automatic Rebuild Policy is set to Free & Spare.
See "Making Controller Settings" on page 68.
WebPAM will report the automatic rebuild in its user interface, as well as via
popup messages, and via email, depending on your settings (see page 57).
You can replace the failed physical drive at your convenience.
96