Handling Guidelines - Analog Devices ADGM1004EBZ User Manual

UG-1078

HANDLING GUIDELINES

Adhere to the following handling guidelines for the evaluation
board:
•
Always treat the ADGM1004
observe normal handling precautions, including working
only on static dissipative surfaces, wearing wrist straps, or
other electrostatic discharge (ESD) control devices.
•
Take care when connecting signals. Hold the
ADGM1004EBZ from the edges to avoid any damage to the
device under test (DUT).
•
Avoid connecting live signal sources. Ensure that outputs
are switched off (preferably grounded) before connecting
as a static sensitive device and
EVAL-
Rev. 0 | Page 8 of 11
EVAL-ADGM1004EBZ User Guide
to the DUT. In addition, ensure all instrumentation shares
a common chassis ground.
•
Avoid running measurement instruments (for example,
digital multimeters (DMMs) in autorange modes). Some
instruments can generate large transient compliance
voltages when switching ranges.
•
Use the highest practical range (that is, lowest resolution)
setting for resistance measurements; this minimizes
compliance voltages.
•
Physically handle the EVAL-ADGM1004EBZ with care.