Configuration Procedure - Siemens SINAUT MD741-1 System Manual

Configuration
3.5

Configuration procedure

The procedure for configuration is as follows:
Carrying out configuration
1. Use the menu to call up the desired settings
area
2. Make the desired entries on the page
concerned or use Reset to delete the current
entry which has not been saved.
3. Use Save to confirm the entries so that they
are accepted by the device.
Note
Depending on how you configure the SINAUT MD741-1, you may then have to
adapt the network interface of the locally connected computer or network
accordingly.
When entering IP addresses, always enter the IP address component numbers
without leading zeros, e.g.: 192.168.0.8.
Invalid entries
The SINAUT MD741-1 checks your entries. Obvious errors are detected during
saving and the input box in question is marked.
Figure 3-7
32
Indication of invalid entries
Figure 3-6 Configuration
SINAUT MD741-1
C79000- G8976-C212