Siemens SINAUT MD741-1 System Manual page 123

Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which
●
the receiver is connected.
Consult the dealer / installer or an experienced radio/TV technician for help.
●
FCC Part 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference
that may cause undesired operation.
FCC Part 15.21
Modifications not expressly approved by this company could void the user's
authority to operate the equipment.
Installation by qualified personnel only
You may only use the SINAUT MD741-1 with an antenna of the SINAUT MD741-1
accessory program.
The installation of the SINAUT MD741-1 and the antenna as well as servicing is to
be performed by qualified technical personnel only. When servicing the antenna, or
working at distances closer than those listed below, ensure the transmitter has
been disabled.
RF Exposure mobile
Caution
Typically, the antenna connected to the transmitter is an omni-directional antenna with
0dB gain. Using this antenna the total composite power in PCS mode is smaller than 1
watt ERP.
The internal / external antennas used for this mobile transmitter must provide a
separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter."
SINAUT MD741-1
C79000- G8976-C212
Applied Standards and Approvals
123