Gill GMX100 User Manual page 56

Gill Instruments Ltd
_____________________________________________________________________________________________________________
Example Summary of MaxiMet Device Settings (GMX550 with GPS option shown):
SETTINGS ARE AS FOLLOWS:
PROTOCOL: GILL
COMMS: RS232
(BAUD): 19200
NODE: Q
OUTFREQ: 1HZ
MSGMODE: CONT
ASCTERM: CRLF
ECHO: ON
ALIGN: 0
SENSOR WIND: ON
UNITS WIND: MS
NODIR: 0.00
AVGSHORT: 60
AVGLONG: 10
SENSOR COMPASS: ON
COMPASSDECL: +000.0
SENSOR GPS: ON
UNITS GPS: MS
SENSOR TEMP: ON
UNITS TEMP: C
SENSOR DEWPOINT: ON
UNITS DEWPOINT: C
SENSOR PRESS: ON
UNITS PRESS: HPA
HASL: +00000.00
HASTN: +00000.00
SENSOR RH: ON
UNITS RH: %
SENSOR PRECIP: ON
UNITS PRECIP: MM
ARPRECIP: ON
REPORT: NODE DIR SPEED CDIR CSPEED PRESS RH TEMP DEWPOINT PRECIPT PRECIPI GPSLOCATION TIME
VOLT STATUS
POWER: 0
TIME: 2016-04-15T12:30:57
AUTOTIME: ON
TZOFFSET: +00.00
PUPMSG STATUS: ON
PUPMSG REPORT: ON
PUPMSG UNITS: ON
MODBUS: RTU
MODADDR: 1
DATABITS: 8
STOPBITS: 1
PARITY: EVEN
MODTERM: 10
MODICT: 1000
Note: Changes to BAUD, COMMS or PROTOCOL settings will take place after next power-up.
Click on the Close button to continue to the MetSet set up screen.
__________________________________________________________________________________________________
MaxiMet
Doc. No. 1957-PS-021
Page 56 Issue 3
May 2018