Gill GMX100 User Manual page 19

Gill Instruments Ltd
_____________________________________________________________________________________________________________
10. Continue to insert all of the contacts you require. Once all of the contacts are inserted push the
red retainer into place. NB: The retainer can only be pushed back into place if the contacts are
fully engaged.
11. Fit the connector to the MaxiMet so that you can finish assembling the connector.
12. Screw the back shell onto the connector until it is fully in place. Please note that the final rotations
can be slightly stiff.
13. Now screw the next part of the connector into place.
14. Now screw the cable-clamping nut into place.
15. The connector can now be removed from the MaxiMet.
Note: To disassemble the connector, reverse this procedure.
__________________________________________________________________________________________________
MaxiMet
Doc. No. 1957-PS-021
Page 19 Issue 3
May 2018