Gill GMX100 User Manual page 49

Gill Instruments Ltd
_____________________________________________________________________________________________________________
GMX501 Factory Default Data String:
Items in red relate to the GPS Option Unit.
NODE, DIR, SPEED, CDIR, CSPEED, PRESS, RH, TEMP, DEWPOINT, SOLARRAD, GPSLOCATION, TIME, VOLT,
STATUS, CHECK
┐Q,021,000.01,090,000.01,1015.3,041,+022.0,+008.5,0000,+50.763004:-001.539898:+3.10,2015-06-
05T10:19:30.8,+05.1,0004,└ 36
Where
┐
Q
021
000.01
090
000.01
1015.3
041
+022.0
+008.5
0000
+50.763004
-001.539898
+3.10
2015-06-05
T10:19:30.8
+05.1
0004
└
36
NOTES:
<STX> is the Start of String character (ASCII value 2).
<ETX> is the End of String character (ASCII value 3).
Checksum, the 2 digit Hex Checksum sum figure is calculated from the Exclusive OR of the bytes between
(and not including) the STX and ETX characters.
MetSet Default Settings
REPORT : NODE DIR SPEED CDIR
VOLT STATUS CHECK
PROTOCOL : GILL
COMMS : RS232
BAUD : 19200
NODE : Q
OUTFREQ : 1HZ
MSGMODE : CONT
__________________________________________________________________________________________________
MaxiMet
Doc. No. 1957-PS-021
STX
Node Letter
Wind Direction
Wind Speed
Corrected Direction
GPS Corrected Speed
Pressure
Relative Humidity
Temperature
Dewpoint
Solar Radiation
GPS Latitude
GPS Longitude
GPS Height location
Date
Time
Supply Voltage
Status
ETX
Checksum
CSPEED PRESS RH TEMP DEWPOINT SOLARRAD
SENSOR COMPASS : ON
COMPASSDECL : +000.0
SENSOR GPS : ON
UNITS GPS : MS
SENSOR TEMP : ON
UNITS TEMP : C
Page 49
GPSLOCATION
POWER : 0
TIME : 2015-06-05T11:04:54
AUTOTIME : ON
TZOFFSET : +00.00
PUPMSG STATUS : ON
PUPMSG REPORT : ON
TIME
Issue 3
May 2018