Twisted Hobbys Crack Turbo Beaver Manual page 25

Locate the Antalizer and glue it to the Prepare to install the wing by hooking Apply a nice thick bead of Welders to
rear center fo the wing assembly. Make up the aileron servo wires to the RX. the saddle area of the fuselage.
sure it is square to the wing. Make sure that when you locate the RX
that you can still reach the bind plug
slot.
Attach the wing using the edges of the Prepare to install the Wing's Side Force Inboard-Forward piece is installed as
saddle in the fuselage as a guide. Generators. shown.
Measure from the tip of each wing to
the tip of the rudder to verify that the
wing is located squarely.
25
Rev: 2013.09.15.v004a