Twisted Hobbys Crack Turbo Beaver Manual page 11

Dip the end of the control rod approx
1/2" into the Welder's nozzle to achieve
a nice even coat of glue.
Apply a medium bead of Welders to one
edge of the wing halves.
Rev: 2013.09.15.v004a
Attach one of the snap links to the end
of the glue coated rod. Note that the
snap link has a small saddle that will
craddle the rod. Repeat for the other
rods and set aside to dry for 24 hrs
Bring the two pieces together, then
seperate. Repeat this 2 or 3 times until
the glue is evenly distributed on both
edges... let the glue tack up for about 5
minutes.
Remove all the little pieces from the cut
outs in the wing halves. Do not remove
the tabs in the wing spar slot at this
time
Once the glue is tacked up bring the
two halves together, make sure that the
dimples and spar slots line up with
each other
11