Twisted Hobbys Crack Turbo Beaver Manual page 21

Glue the two piece together, making
sure they are square to each other.
Let the assembly dry for an hour or so
before handling.
Rev: 2013.09.15.v004a
Set them aside to dry.
Add the lower rudder fin. This is also
the time to glue the bottom of the
rudder to the back of the fuselage.
Once dry the tail assembly can be
jointed to the fuselage. Do not put glue
on the bottom most part of the rudder,
this will be glued with the fin.
Install the ESC. In this case the ESC
will be installed under the cowling, but
in warm areas it should be left in the
open, exposed to good airflow.
21