Twisted Hobbys Crack Turbo Beaver Manual page 14

While the glue is still wet on the EPP
pieces, install the wood hubs on the
front and back, again wet and with a
medium coat of Welders.
Once the carbon strips have dried in
the struts, test fit the little axle holders
into the ends. Note that they are not
symetrical.
Rev: 2013.09.15.v004a
Install one of the axles thru the center
of the hubs to insure the concentricity
of all the parts. Adjust by sliding the
parts around as necessary
Let the finished assmbly dry for a bit.
We will wrap this area with thread and
glue in a later step.
Repeat with the other wheel and set
aside under some weight to dry.
NOTE:
READ OVER THE NEXT
SIX STEPS. FULLY
UNDERSTAND AND
TEST FIT HOW THE
FUSELAGE PIECES FIT
TOGETHER. THIS IS A
UNIQUE DESIGN AND
MUST BE DONE
PROPERLY FOR A
SQUARE AND TRUE
AIRFRAME.
14