Aaeon SBC-598 Manual page 21

DiskOnChip (DOC) 2000 Installation
When the DOC is installed correctly, a DOC will work like a
HDD or a FDD. To install the DOC on the mainboard, follow the
instructions below:
1. Plug the DOC into the socket. Make sure pin 1 of the DOC is
aligned with pin 1 of the socket.
2. Push the DOC into the socket until it is firmly seated in the
socket.
Caution: the DOC may be permanently damaged if it is
installed incorrectly.
3. Set the jumper for the memory address of the DOC.
Note:
The memory shadow function sometimes will create con-
flicts with the memory window. You should disable the
memory shadow from the BIOS SETUP if the DOC cannot be
accessed.
Configure DOC as a boot device
To configure a DOC as a boot drive, you should copy the operat-
ing system files into the DOC. The following procedure is an
example of the initialization process.
1. Install a DOC into your system.
2. Insert a bootable floppy disk in drive A: and boot the system.
3. At the DOS prompt, type SYS C: to transfer the DOS system
files to the DOC (assuming the DiskOnChip is installed as
drive C:). Reboot the system.
4. Go to the BIOS Setup Utility by hitting the <DEL> key. Set
the type of Primary Master or C: Drive as Not Installed.
5. Remove the floppy disk from the drive A: and leave the BIOS
Setup Utility. The system should boot from the DOC.
Chapter 2 Installation 13