Aaeon SBC-598 Manual page 18

Installing SIMMs
Note that the modules can only fit into a socket one way.
1. Insert the memory module into the socket at a moderate angle.
2. Push the module toward the vertical posts at both ends of the
socket until the module is upright and the retaining clips at both
ends of the module click into place. When positioned correctly,
the pins on top of the vertical posts should correspond to the
circular holes on the ends of the module.
3. Repeat steps 1 and 2 for each module you install.
Removing SIMMs
1. Supporting the SIMM with a finger, use a pen or a similarly
shaped object and press one retaining clip straight down.
2. Repeat for the other side. When released, the retaining clips will
push the SIMM up and out of its upright position.
3. Carefully pull the SIMM out of the socket with your fingers.
4. Repeat the above steps for each module you remove.
10 SBC-598 User Manual