Sargent H1 Installation Instructions Manual page 12

Step #8 – Stallation of the Inside Rose and Inside Lever Assembly
1. Rotate inside rose clockwise.
2. Slide lever handle onto spindle until fully
seated. Be sure handle is horizontal and
facing to the rear of the door.
3. Tighten the set screw securely with
1/8" hex wrench.
Step #9 – Installation of Outside Cylinder
1. Verify orientation of cylinder (Ref. to Fig. 3).
2. Tighten the cylinder clamp screw to prevent unscrewing of the cylinder (Ref. Fig. 2).
3. Test cylinder function: 78 Function - Key retracts latch 76 Function - Key retracts latch and projects and
retracts deadbolt.
90 1/8 Cylinder Ring
Type 43 Mortise
Cylinder only
Fig 1
For installation assistance, contact SARGENT at 800-810-WIRE (9473)
Harmony Series H1 Mortise Lock
Rose
Set Screw
Spindle
Fig. 1
Fig 2
A7877A
Inside Lever
Inside of door
Fig. 2
Note: Key and
cylinder must be
rotated as shown
SARGENT
Correct
Set Screw
Fig 3
Phillips
Screwdriver
© SARGENT Manufacturing Company 2007
Incorrect
9