Setpoint Direct Access; Reset Pin Numbers / View Firmware Version - Define Instruments PRO-CTR200 Manual

10

SETPOINT DIRECT ACCESS

If none of the setpoints have their direct access option enabled then this feature will
be disabled and the
A Begin by pressing the
B The name of the fi rst access-enabled setpoint will appear in and the current
value for that setpoint will appear. Using the
selected value. Then press
C The name of the next access-enabled setpoint will appear on the display, along
with its setpoint value. Repeat step 10B. The direct access menu will proceed
through all access-enabled setpoints in this fashion. Pressing
bled setpoint will exit and return to the operational display.
11

RESET PIN NUMBERS / VIEW FIRMWARE VERSION

If you have forgotten your PIN number(s), follow the procedure below to reset both
the CAL and SP PINs to their factory default of 1.
This procedure will also allow you to view the current soft ware installed on your
controller, which may be required for support purposes.
A Press ,
execute and you may need several tries to get it right.)
B A message will appear on the display, with details of the unit's current soft ware
confi guration (Product Name, Firmware Version, and Macro Version). At the
end, you will see – PIN NUMBERS RESET TO 1.
C Both the CAL and SP PIN's have now been reset to '1'. You can change this, if
required, by following the instructions in 8.8 (for Input Setup & Calibration) and
9.3 (for Setpoint Setup), using '1' to enter each menu initially.
Copyright © 2016 Defi ne Instruments
button will not respond to a short button press. (See 9.2Q.)
button for less than 3 seconds.
to accept and continue.
and at the same time. (This key combination can be diffi cult to
and buttons, adjust the
for the last ena-
PRO-CTR-MAN-16V03 (0128)
31