Table of Contents
Advertisement
G
_ _ _ CAL HIGH ANALOG OUTPUT scrolls across the display. A calibration num-
ber displayed in internal units (mA/V) appears. Using the
calibrate your high analog output as required, and press
8.7 - Serial setup
A
_ _ _ SERIAL SETUP scrolls across the display, and SKIP appears. If your control-
ler does not have a serial port installed, (or you do not wish to confi gure your
serial options now), please press
Otherwise, press the
B
_ _ _ SERIAL MODE scrolls across the display, and the currently selected serial
mode appears. Using the
MODBUS (RTU) or RNGR A (Ranger A), and then press
See Appendix A [p32] for more information about the available serial modes.
If you selected ASCII or MODBUS, skip to 8.7D now.
If you selected RANGER A, continue to 8.7C now.
C
_ _ _ SERIAL DATA SOURCE scrolls across the display, and the current Ranger A
serial data source appears. Use the
PRMCTR, B CNTR, C CNTR, RATE, BATCH or BCHCNT, and then press
D
_ _ _ BAUD RATE scrolls across the display, and the current selection appears.
Use the
and
38400, 57600 or 115200 Then press
E
_ _ _ PARITY scrolls across the display, and the currently selected parity appears.
Using the
F
_ _ _ SERIAL ADDRESS scrolls across the display, and the serial address appears.
Use the
and
The serial address parameter is used to identify a particular device when it is used with other
devices in a system. (It applies particularly to MODBUS mode when used on an RS485 serial
network.) The serial address of the controller must be set to match the serial address defi ned
in the master device.
Refer to Appendix A [p32] for more information on serial modes and registers.
Copyright © 2016 Defi ne Instruments
button and then
and
buttons to select one of: 1200, 2400, 4800, 9600, 19200,
and
buttons, select: NONE, ODD or EVEN, and then press
buttons to alter the serial address, and then press
to skip to 8.8.
to ENTER serial setup.
buttons, choose either: ASCII (custom),
and
buttons to select an option from:
.
and
buttons,
.
.
.
PRO-CTR-MAN-16V03 (0128)
25
.
.
Advertisement
Table of Contents
Need help?
Do you have a question about the PRO-CTR200 and is the answer not in the manual?