Define Instruments PRO-CTR200 Manual page 12

Counter/rate controller
Table of Contents

Advertisement

12
5.2 - Installation instructions
A
Prepare the Panel Cutout to
92 x 45mm ±.5 (3.62 x 1.77" ±.02),
as shown below.
Allow at least 155mm (6.10")
depth behind the panel to accom-
modate the meter body, protrud-
ing connectors and cabling.
B
Remove the Mounting Clips from
the meter back.
Panel
Screws
PRO-CTR-MAN-16V03 (0128)
Meter Faceplate
Panel
Gasket
Mounting
Clips
C
Slide the Panel Gasket over the
rear of the unit to the back of the
Meter Faceplate.
D
From the front of the panel, insert
the meter into the Panel Cutout.
Holding the unit in place, engage
the Mounting Clips so that the tabs
snap into place over the notches on
the case.
E
To achieve a proper seal, tighten
the Screws evenly until the unit sits
fi rmly against the panel. Do not
over-tighten the screws.
Panel Cutout
92mm
±.5
(3.62"
±.02
Copyright © 2016 Defi ne Instruments
)
45mm
±.5
(1.77"
)
±.02

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRO-CTR200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Pro-ctr100

Table of Contents