General Safety Instructions - AGFA CR 10-X User Manual

General safety instructions

• Make sure that the digitizer is constantly monitored in order to avoid
inappropriate handling, especially by children.
• Only trained service personnel must make repairs. Only authorized service
personnel must make changes to the digitizer.
• If there is any visible damage to the machine casing, do not start nor use
the digitizer.
• Do not override or disconnect the integrated safety features.
• Do not apply excessive force when inserting a cassette into the digitizer.
• Do not insert a cassette when the digitizer is switched off.
• Do not apply excessive shock or vibration to the digitizer during operation
(e.g. putting cassettes on top of the device). This may decrease the image
quality. Neither should the device be moved during operation.
CAUTION:
The digitizer is not suitable for scanning imaging plates (IPs)
exposed with a dose higher than 5000 µG and for CR HD5.0S
General a dose higher than 2500 µG.
CAUTION:
Pushing the release button during scanning or during
erasure stops operation immediately and can cause an
image being lost, a need to retake the image or delayed
diagnosis.
Do not push the release button during scanning (status indicator
is blinking yellow) or during erasure (status indicator blue).
CAUTION:
Power failure can cause an image being lost.
Connect the workstation and the digitizer to an uninterrupted
power supply (UPS) or an institutional standby generator.
CAUTION:
Bad image quality can cause a need to retake the image or
cause delayed diagnosis.
Do not operate the device in direct sunlight, max. 2500 lux.
CAUTION:
Device failure and image loss can cause a need to retake the
image or cause delayed diagnosis.
Perform no other operations on the digitizer than those
described in this document.
CAUTION:
While every care has been taken, it is possible that minor errors
still exist in the product. It is unlikely that a minor error could
result in incorrect (unexpected) device operation.
CR 10-X, CR 12-X, CR 15-X | Introduction | 35
2491E EN 20150409 1543