Chapter 3:
Hardware Setup
Preparing the Hardware Installation
WARNING:
To reduce the risk of personal injury,
electric shock, or damage to the equipment,
please remove all power connections
to completely shut down the device.
Also, please wear ESD protection gloves
to conduct the steps in this chapter.
1.
Power off the FW-8896 and make sure the power cord
is disconnected from the device.
2.
Loosen the 2 thumbscrews from the rear panel of the
FW-8896 System.
3.
Gently pull the cover backward
4.
Open the cover from the side.
4
1
unscrew the thumbscrews on
the back and open the top
2
cover.
3
5. Removed the screws circled in the image below to
take away the protection cover for CPUs and other
connectors.