Chapter 4: Hardware Setup; Accessing The Cpu Blade(S) - Lanner HTCA-6600 User Manual

Chapter 4: Hardware Setup

Preparing the Hardware Installation
To access some components and perform certain service procedures, you must perform the
following procedures first.
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, please
remove all power sources.
Please wear ESD protected gloves before conducting the following steps.

Accessing the CPU Blade(s)

You have to access the CPU blade(s) in order to install or replace CPUs, heatsinks and DDR
memory DIMMs. Please follow the steps below to access CPU blades.
1. Select a CPU blade you wish to access the internal components.
2. Rotate and loosen the captive screws circled in the picture below. You may apply a
screwdriver to conduct this task.
Network Computing Platforms