Viewing Pedometer Data; Viewing Stopwatch Data - Casio 5554 Operation Manual

Triggering Immediate Time Adjustment
●
The watch will synchronize its time setting to
that of the phone immediately when they are
connected with each other. Whenever you
want to adjust the watch's time setting based
on your phone's time, perform the procedure
below to connect with a phone.
1.
X Press (D).
This causes e and [ADJ] to flash on the
display. e will stop flashing when a
connection is established between the
watch and phone, and the watch's time
setting will be synchronized with that of
the phone.
Trying to connect Following time
Note
The connection is terminated
●
automatically after time adjustment is
complete.
If time synchronization fails for some
●
reason, the watch will return to the
Timekeeping Mode without changing
its time setting.
Operation Guide 5554

Viewing Pedometer Data

G-SHOCK Connected can be used to view the
data below, which is measured by the watch.
24-hour step count, exercise intensity, and
●
physical exertion
Whether or not there is a stopwatch
●
measurement or timer measurement
(24 hours of data displayed by dividing it into
30-minute segments.)
Weekly number of steps, calories burned
●
1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Hold down (D) for about two seconds.
correction
When a connection is established
between the watch and phone, e will stop
flashing.
Trying to connect
3.
Y Follow the instructions on the screen to
display pedometer data.
Note
You can also use G-SHOCK
●
Connected to specify a daily step
target.
Though the step count is displayed on
●
the watch in real time, G-SHOCK
Connected displays step counts at the
top of each hour and every half hour.
Because of this the step counts
displayed by G-SHOCK Connected
may be different from those displayed
by the watch.

Viewing Stopwatch Data

This section explains how to send lap times
and split times (up to 200 records) stored in
watch memory, and other data to your phone
for viewing with G-SHOCK Connected.
Sending Stopwatch Data to a Phone
●
Use the procedure below to send data from
the watch to a phone.
1.
2.
Trying to connect
Connection successful
3.
Checking Sent Data
●
Use G-SHOCK Connected to check the data
you sent to the phone.
1.
2.
Note
Y Tap the "G-SHOCK Connected" icon.
X Hold down (D) for about two seconds.
When a connection is established
between the watch and phone, e will stop
flashing.
Connection successful
Y Perform the operation shown on the
phone screen to transfer data measured
by the watch to the phone.
After data transfer is complete, a list of the
measurement data will appear on the
phone display.
Tapping a stopwatch data item displays
●
its details.
Y Tap the "G-SHOCK Connected" icon.
Y Perform the operation shown on the
phone screen to view the measurement
data you want.
You can delete data by tapping [Edit].
●
5