Calibrating Temperature Readings (Offset); Specifying The Temperature Unit; Temperature Reading Precautions; Viewing Altitude Records - Casio 5601 Operation Manual

Calibrating Temperature
Readings (Offset)
The watch's temperature sensor is adjusted at
the factory and normally does not require
calibration. However, you can calibrate the
displayed value if you notice major errors in
readings.
Important!
Check to make sure that the value you
●
use for calibration produces correct
temperature readings.
Before calibrating the temperature
●
reading, remove the watch from your
wrist and leave it in the area where you
plan to measure temperature for about
20 or 30 minutes to allow the case
temperature to become the same as
the air temperature.
1.
Enter the Thermometer Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least two seconds.
Release the button when [SET] starts to
flash and then [°C] appears on the display.
This displays the current temperature and
enters the Temperature Offset Mode.
3.
Use (A) and (C) to calibrate the
temperature.
Calibration unit: 0.1 °C (0.2 °F)
To return the barometric pressure
●
setting to its initial factory default, press
(A) and (C) at the same time.
4.
Press (D) to exit the setting screen.
Specifying the Temperature
Unit
You can select either Celsius (°C) or
Fahrenheit (°F) as the temperature display
unit.
Important!
When Tokyo (TOKYO) is the Home
●
City, the temperature unit is fixed as
Celsius (°C) and cannot be changed.
Operation Guide 5601
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
Example: When your Home City is Los
Angeles
3.
Press (E) nine times.
This will display [UNIT °C] with [°C]
flashing, or [UNIT °F] with [°F] flashing.
4.
Press (A) to toggle between temperature
units.
[°C]: Celsius
[°F]: Fahrenheit
Celsius
5.
Press (D) twice to exit the setting screen.
Temperature Reading
Precautions
Body temperature, direct sunlight, and
humidity all have an effect on temperature
readings. To help ensure more accurate
temperature readings, remove the watch from
your wrist, wipe it dry of any moisture, and
place it in a well-ventilated location not
exposed to direct sunlight. You should be able
to take temperature readings after about 20 to
30 minutes.
You can use the Altitude Record Recall Mode
to view manually recorded and auto recorded
data.
Recording Altitude Readings
l

Viewing Saved Data

Home City
1.
Enter the Altitude Record Recall Mode.
Navigating Between Modes
l
This displays a record of data recorded in
the Altimeter Mode.
2.
Use (A) and (C) to display the data you
want to view.
Holding down (A) or (C) scrolls at high
●
speed.
A
Fahrenheit
Total Descent
A
Total Ascent
* Each press of a button scrolls to the top
screen of the next manually recorded
data record. There can be up to 14
records in memory, numbered from 1
([-01-]) to 14 ([-14-]).
Viewing Altitude
Records
Manually Recorded Data
A*
C*
C C
Auto Recorded Data
High Altitude
C C
Low Altitude
C
A
A
A
26