Table of Contents
Advertisement
Specifying the Illumination
Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for about two seconds.
Release the button when [SET] stops
flashing.
3.
Press (C) nine times to display [LT].
4.
Press (D) to toggle between the two
illumination duration settings.
[1]: 1.5-second illumination
[3]: 3-second illumination
5.
Press (A) to exit the setting screen.
Operation Guide 5554
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Getting Ready
Enter the Timekeeping Mode.
Navigating Between Modes
l
Adjusting Hand Alignment
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down the (A) button for about five
seconds until [12:00] flashes on the
display.
This enables adjustment of the hour and
minute hands.
Two seconds later
3.
If the hour hand and minute hand are not
at 12 o'clock, use the (D) and (B) buttons
to align them.
4.
Press (A) to exit the setting screen.
Battery Replacement
When battery power goes low,
flash and some functions will become
disabled. If
continues to flash, replace the
battery.
Getting Ready
Enter the Timekeeping Mode.
Navigating Between Modes
l
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Enter the Timekeeping Mode.
l
2.
Hold down (A) for about two seconds.
Release the button when [SET] stops
flashing.
Five seconds later
3.
Press (C) eight times to display [♪].
4.
Press (D) to toggle the button operation
tone between enabled and disabled.
[On]: Operation tone enabled.
[OFF]: Operation tone disabled.
will start to
5.
Press (A) to exit the setting screen.
Other Settings
Navigating Between Modes
19
Hide quick links:
Advertisement
Table of Contents
