Measuring Elapsed Time With The Target Time Function; Clearing Target Times; Viewing Measured Time Data; Viewing Data Records - Casio 5554 Operation Manual

Measuring Elapsed Time with the
Target Time Function
You can perform the same elapsed time
operations as those described in the sections
below.
Measuring Elapsed Time
l
Measuring a Split Time
l
Measuring Lap Times
l
Starting an elapsed time operation will cause
[TGT] to flash on the display.
An alarm will sound for 10 seconds to let you
know when the elapsed time operation
reaches a target time you set.
[TGT] disappears from the display when the
elapsed time operation exceeds the last target
time.
Reset
D
Start
Target time reached.
Stop *
* [TGT] is displayed if you stop the elapsed
time measurement operation before the target
time was reached.
Operation Guide 5554

Clearing Target Times

The procedure below restores target time
settings to their initial factory defaults.
Target Time 1: 5 minutes
●
Target Time Function: Off
●
1.
Hold down (A) for about two seconds.
2.
Hold down (B) and (D) at the same time
for about five seconds until [ALL] stops
flashing on the display.
This restores target time settings to their
initial factory defaults.
3.
Press (A) to complete the operation.

Viewing Measured Time Data

Viewing Data Records

You can use the operation below to view split
times and lap times.
1.
Enter the Recall Mode.
Navigating Between Modes
l
This causes the record number of the
●
latest measurement to appear.
Record number
2.
Hold down (A) for about two seconds to
cycle through record numbers.
Each time you hold down (A), the next
●
older record number appears.
A
2 seconds
A
2 seconds
A
2 seconds
A
2 seconds
3.
Use (D) and (B) to display the
measurement value you want.
D
B
Press (A) to toggle the measurement
●
value display between lap time and split
time.
Lap
A
Note
A record of the measured data is
●
created and assigned a number for
each measurement operation (from
start to stop).
Split
13