Table of Contents
Advertisement
Auto Time Adjustment
The watch will connect with a phone at preset
times each day and adjust its time settings.
Using This Function
●
Your watch adjusts its time setting four times
a day according to a preset schedule. If you
leave the watch in the Calendar Mode, it will
perform the adjustment operation
automatically as you go about your daily life,
without any operation required by you.
Important!
The watch may not be able to perform
●
auto time adjustment under the
conditions described below.
While the watch is too far away from
ー
its paired phone
While communication is not possible
ー
due to radio interference, etc.
While the phone is updating its
ー
system
While EDIFICE Connected is not
ー
running on the phone
Note
If the watch does not indicate the
●
correct time even if it is able to connect
with a phone, adjust the hand and day
indicator positions.
Adjusting Hand and Day Indicator
l
Alignment
If there is a World Time City specified
●
with EDIFICE Connected, its time will
also be adjusted automatically.
The watch will connect with the phone
●
and perform auto time adjustment at
around 12:30 a.m., 6:30 a.m., 12:30
p.m. and 6:30 p.m. The connection is
automatically terminated after auto
time adjustment is complete.
Watch Operation Guide 5666
Triggering Immediate Time Adjustment
●
The watch's time setting will be adjusted
automatically whenever you establish a
connection between the watch and a phone.
Whenever you want to trigger immediate time
adjustment, perform the procedure below to
connect with a phone.
1.
Move the phone close to (within one meter
of) the watch.
2. X
Enter the Calendar Mode.
Navigating Between Modes
l
3. X
Hold down (B) for at least 0.5 seconds
until the second hand points to [R].
Release the button as soon as the second
hand points to [R].
When the watch connects with a phone,
the second hand will normally move to
and then the watch's time setting will be
adjusted.
The connection is terminated
●
automatically after time adjustment is
complete.
Connected
Viewing Stopwatch Data
This section explains how to send lap times
(up to 200 records) that are stored in watch
memory, as well as other data to your phone
for viewing with EDIFICE Connected.
Sending Stopwatch Data to a Phone
●
Use the procedure below to send data from
the watch to a phone.
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3. Y
Checking a Lap Time
●
Use EDIFICE Connected to check the data
you sent to the phone.
1. Y
2. Y
e
Note
After time adjustment
Setting the Alarm
1. Y
2. X
3. Y
Perform the operation shown on the
phone screen to transfer data measured
by the watch to the phone.
After data transfer is complete, a list of the
measurement data will appear on the
phone display.
Tapping a stopwatch data item displays
●
its details.
Tap the "EDIFICE Connected" icon.
Perform the operation shown on the
phone screen to view the measurement
data you want.
Tapping "Edit" displays a screen that
●
you can use to change the data item
title and to delete lap time data.
Tap the "EDIFICE Connected" icon.
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
Perform the operation shown on the
phone screen to configure alarm time
settings.
11
Advertisement
Table of Contents
