Configuring The Summer Time Setting; Swapping Your Current Location Time And World Time; Measuring Elapsed Time - Casio Edifice ECB-500D-1A Operation Manual

Note
To look up the current time in a city
●
that is not among the built-in cities,
select a built-in city that is in the
same time zone as the city you want
to look up. For information about
built-in cities, see the "City Name
List".
Configuring the Summer
Time Setting
When summer time is used in a World Time
city, you can enable Summer Time for that city.
Summer Time
l
1.
Hold down the (A) button for about two
seconds.
[SET] will appear first, followed by the
Home Time City name.
2.
Press (A) and then (D).
3.
Press (E) to cycle through the summer
time settings below.
[AT]
●
The watch switches between standard
time and summer time automatically.
[--]
●
The watch always indicates standard
time.
[ON]
●
The watch always indicates summer
time.
4.
Press (A) to return to the Timekeeping
Mode.
Operation Guide 5427
Note
The summer time setting of the
●
watch is "AT (Auto)" when you
purchase it, so it will switch between
standard time and summer time
automatically. You do not need to
switch between standard time and
summer time manually. Even if you
are in an area that does not observe
summer time, you can leave the
watch's summer time setting as "AT
(Auto)".
For information about summer time
●
switching dates, see the
Time Table.
Swapping Your Current
Location Time and World
Time
Holding down (E) for about three seconds will
swap your World Time with your current
location time.
In the Timekeeping Mode, you can swap the
●
time indicated by the main hands with the
time indicated by the small hour hand and
minute hand.
Before swapping
Current location time
World Time
The stopwatch can measure elapsed time up
to 23 hours, 59 minutes, 59 seconds.
It can also measure split times.
Getting ready
Perform this procedure in the Stopwatch
Mode. Use (D) to navigate to the Stopwatch
Mode.
l
Summer
1.
After swapping
Current location time
n
World Time
2.
3.
Stopwatch
Navigating Between Modes
Stopwatch Mode

Measuring Elapsed Time

Use the operations below to measure
elapsed time.
E
Start
E
Stop
E
Resume
E
Stop
First hour After first hour
1/100 seconds
n
Seconds
Elapsed hours,
Minutes
minutes
Hours
Press (A) to reset the elapsed time to all
zeroes.
Press (D) three times to return to the
Timekeeping Mode.
Seconds
11