Looking Up Sunrise And Sunset Times By Specifying A Day; Looking Up Sunrise And Sunset Times By Specifying A Location; Stopwatch; Measuring Elapsed Time - Casio G-Shock GW-9500-1A4 Installation Instruction

Looking Up Sunrise and
Sunset Times by Specifying a
Day
1.
Enter the Sunrise/Sunset Mode.
Navigating Between Modes
l
2.
Use (A) and (C) to select the day you want.
This displays the sunrise and sunset
times for the day you specified.
Holding down (A) or (C) scrolls through
●
settings at high speed.
Month, day Sunrise time
Year Sunset time
Looking Up Sunrise and
Sunset Times by Specifying a
Location
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (E) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3.
Use (A) and (C) to select the city name of
the location whose sunrise/sunset times
you want to look up.
Holding down (A) or (C) scrolls through
●
settings at high speed.
If you don't need to specify a latitude
●
and longitude, press (E) twice and
advance to step 8.
4.
Press (E).
This displays the latitude or longitude
setting screen.
Watch Operation Guide 3553
5.
Press (D) to toggle between the latitude
and longitude setting screens.
Latitude screen
6.
Use (A) and (C) to specify an angle.
Setting ranges are shown below.
Latitude: 65.0°S (65.0 degrees south
latitude) to 0.0°N to 65.0°N (65.0 degrees
north latitude)
Longitude: 179.9°W (179.9 degrees west
longitude) to 0.0°E to 180.0°E (180.0
degrees east longitude)
You can change the setting in 0.1°
●
increments.
Holding down (A) or (C) scrolls through
●
settings at high speed.
7.
Press (E) to return to the Timekeeping
Mode.
8.
Press (D).
This displays the sunrise/sunset times for
the location you specified.
Important!
If you specify a city that is not your
●
Home City
Home City as the location when
checking sunrise and sunset times, be
sure to change back to your Home City
setting after you are finished. If you
don't, the watch will not display the
correct current time.
Setting a Home City
l
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
The stopwatch performs elapsed time
Longitude screen
measurement up to 999 hours, 59 minutes,
59.9 seconds in 1/10 second units.
It can also measure split times.

Measuring Elapsed Time

1.
Enter the Stopwatch Mode.
l
2.
Use the operations below to measure
elapsed time.
3.
Press (C) to reset the measurement time
to all zeros.

Stopwatch

Navigating Between Modes
A
Start
A
Stop
A
Resume
A
Stop
Hours
Minutes, seconds, 1/10 seconds
31