Enable The H.265 Stream Access; Upgrade The Ip Camera - HIKVISION DS-9616NI-I8 User Manual

 The PoE ports are enabled with the short distance mode by default.
 The bandwidth of IP camera connected to the PoE via long network cable (100 to 300 meters)
cannot exceed 6 MP.
 The allowed max. long network cable may be less than 300 meters depending on different IP
camera models and cable materials.
 When the transmission distance reaches 100 to 250 meters, you must use the CAT5E or CAT6
network cable to connect with the PoE interface.
 When the transmission distance reaches 250 to 300 meters, you must use the CAT6 network cable
to connect with the PoE interface.
 Refer to the Appendix 20.4 List of IP Cameras Connected to PoE by Long Network Cable (100 - 300
m) for the list of IP cameras.
Step 3 Click Apply.

3.3 Enable the H.265 Stream Access

The device can automatically switch to the H.265 stream of IP camera (which supports H.265 video
format) for the initial access.
Step 1 Go to More Settings > H.265 Auto Switch Configuration at the top taskbar.
Step 2 Check the checkbox of Enable H.265 (For Initial Access).
Step 3 Click OK.

3.4 Upgrade the IP Camera

The IP camera can be remotely upgraded through the device.
Plug the U-flash drive with the IP camera's firmware upgrade file to the device.
Step 1 On the camera management interface, select a camera.
Step 2 Go to More Settings > Upgrade at the top taskbar.
Step 3 Select the firmware upgrade file from the U-flash drive.
Step 4 Click Upgrade.
Result:
The IP camera will reboot automatically after the upgrading completes.
Network Video Recorder User Manual
56