Setting Applications And Communication Conditions; Applications To Be Set For Each Port; Conditions To Be Set For Each Port - Panasonic FP7 User Manual

Setting and Confirming Communication Conditions

3.1 Setting Applications and Communication Conditions

3.1.1 Applications to be Set for Each Port


Unit Type
Communication
PLC link
port
COM0
COM1
COM2
(Note 1) In MEWTOCOL7-COM, there is no master communication function.

3.1.2 Conditions to be Set for Each Port


Communication condition
Communication port
Station no.
Baud rate
Data length
Parity
Communica
Stop bit
tion format
End code
Start code
RS/CS controlled
Send Waiting
Modem initialization
(Note) Communication conditions that can be set vary by the mode to be used (PLC link, MEWTOCOL
communication, MODBUS-RTU, general-purpose communication).
3-2
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
MEWTOCOL7-COM
MEWTOCOL-COM
Master
○ (Note 1)
● ○ (Note 1)
○ (Note 1)
1 - 99 (MEWTOCOL-COM)
1 - 999 (MEWTOCOL7-COM)
1 - 247 (MODBUS-RTU)
300,600,1200,2400,4800,9600,19200,38400,57600,115200,230400
7 bits, 8 bits
None, Odd, Even
1 bit, 2 bits
CR, CR+LF, ETX , or time (0.01 ms – 100 ms, by the unit of 0.01 ms)
With STX, Without STX
No/Yes
0 to 100 ms
Invalid, Valid, Re-initialization
MODBUS-RTU
Slave Master
● ●
● ●
● ●
Setting range
General-purpose
communication
Slave
● ●
● ●
● ●
Default
1
9600
8 bits
Odd
1 bit
CR
Without
STX
Invalid
0 ms
Invalid