Communication Setting; Setting The Lan Port; Adding Usb Ports - Panasonic GM1 Series User Manual

10.3 Communication Setting

10.3 Communication Setting

10.3.1 Setting the LAN Port

Configure communication settings for the LAN port using "Network setting" in the "PLC
Parameters" tab.
When connecting GM Programmer and the GM1 Controller via the LAN port, match the network
settings of the PC with those of the GM1 Controller.
1.
Double-click the "Device(AGM1CSEC16T/P)" object in the navigator pane.
The device editor will open.
2.
Open the "PLC Parameters" tab.
3.
Check the network settings of the GM1 Controller and match the network settings of the PC
with those of the GM1 Controller.
4.
Open the "Communication Settings" tab and click "Network scan".
5.
Select a GM1 Controller to which you want to connect and click the [OK] button.
● If the network settings of the GM1 Controller have been changed, the changes will take
effect after the project is downloaded.

10.3.2 Adding USB Ports

This function allows the user to set a USB port as the communication interface between a tool
such as GM Programmer or PANATERM Lite for GM and the GM1 Controller.
1.
Connect the GM1 Controller and PC with a USB cable.
2.
From the menu bar, select Online>Add USB Port.
10-6 WUME-GM1ETCSU-01