Panasonic FP7 User Manual page 41

 Output signal
Output Communication
signal port
Y0 For COM.1 Port
Y1 For COM.2 Port
Y2 For COM.0 Port
Y3
-
- Y7
Y8 For COM.1 Port
Y9 For COM.2 Port
YA For COM.0 Port
YB -
YC For COM.1 Port
YD For COM.2 Port
YE For COM.0 Port
YF -
Y10 For COM.1 Port
Y11 For COM.2 Port
Y12 For COM.0 Port
Y13 -
Y14 For COM.1 Port
Y15 -
-
Y1F
(Note 1) When transmission is completed within one scan, it turns off when the GPSEND command is executed in the
subsequent scan.
NOTE

Each contact in the table above is used for reading the operation status. Do
not write over it with a user program. (excluding Y10 - Y12 and Y14)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
3.2 Input/Output Signals Used for Communication
Name
Reports the result of sending in master
communication or general-purpose
Sending done
communication.
result
Normal completion: 0, Abnormal completion: 1
Undefined Do not turn on "undefined". (Default setting is 0.)
It turns on (1) during sending in the general-
Sending general-
purpose communication mode.
purpose
(Note 1)
communication
flag
Sending done: 0, Sending: 1
Undefined Do not turn on "undefined". (Default setting is 0.)
It turns on (1) during sending in the master
Sending master
communication mode.
communication
flag
Sending done: 0, Sending: 1
Undefined Do not turn on "undefined". (Default setting is 0.)
By turning on (1) Y10 - Y12, the communication
channel can be reset.
Without a request to reset = 0, With a request to
reset = 1
After ON (1) is output and the completion of the
reset is confirmed by X10 - X12, return to OFF
(0). The reset is performed only once when this
Request to reset signal rises.
CH
This function can be used to delete
unnecessary received data or to clear errors
before starting normal reception.
1: Sending canceled
2: Reception canceled
3: Re-set communication parameters
4: Clear error information (only for errors that
can be cleared)
Undefined Do not turn on "undefined". (Default setting is 0.)
By turning on (1) this output, RTS is controlled.
Transmission from the communication partner is
permitted = 0
Output
Transmission from the communication partner is
RTS signal
prohibited＝1
Monitor the CTS signal from the communication
partner with X14.
Undefined Do not turn on "undefined". (Default setting is 0.) -
Description Valid
communication
mode
MEWTOCOL
MODBUS-RTU
General-purpose
communication
General-purpose
communication
MEWTOCOL
MODBUS-RTU
General-purpose
communication
When RS/CS is
set to valid in
Communication
Cassette COM1
3-5