Parmco VERSO X9F Installation And Operating Instructions Manual page 9

INSTALLATION
Electrical connection
Warning!
All electrical work must be carried out by a suitably qualified and authorized electrician. No alterations or
willful changes in the electricity supply should be carried out.
Before attempting the connection, check whether the voltage indicated on the rating plate corresponds to
●
the actual mains voltage.
Mains lead should be minimum 1.5m long.
●
Earthing wire should be installed in such manner to be the last one pulled out in case the safety relief
●
device of the mains lead should fail.
Mains lead behind the oven must be placed in such manner to avoid touching the back panel of the oven
●
because of the heat it develops during operation.
The cable of correct size rating must be used cable type H05VV-F 3×1.5m m
●
than the other wires.
Connection (by authorised electrician)
Using the screwdriver open the connector cover at the rear of the appliance. Release two locks located at
●
either side of the connector bottom.
Mains lead must be led through the relief safety device, protecting the mains lead cable from disconnection.
●
Tighten the relief device securely and close the connector cover.
●
Colour code
L=exterior live wires, usually coloured black, brown.
N=neutral
220-240V 50/60Hz
8
.
2
the grounding wire shall be longer