Parmco VERSO X9F Installation And Operating Instructions Manual page 11

2. The current time can be set with button 1 and 3, 5 seconds after the time has been set, the
new data will be saved.
Timer
The timer can be activated at any time and any function, the timer can be set from 1 minute to
23 hours and 59 minutes;
To set the timer you should:
1. Press button 2, flashing
2. Set the timer using buttons 1 and 3.
3. 5 seconds after the time is set, or directly press the button 2, the signal function
your setting is saved.
4. When the set time is up the alarm signal will be activated and the signal function start
flashing again.
5. Press any button, the signal function
be turned off automatically after 2 minutes.
M
1 2 3
.Enter the timer setting.
M
1 2 3
M
1 2 3
M
1 2 3
M
1 2 3
and alarm signal will go off, or the alarm signal will
10
is on.