Installing The Ic Socket - Renesas H8SX/1638 User Manual

Section 2 Connection Procedures
To connect the board to the user system, follow the instructions below.
2.1.1

Installing the IC Socket

After checking the location of pin 1 on the IC socket fasten it to the user system before soldering.
After confirming the location of pin 1 on the IC socket,
apply epoxy resin adhesive to the end of the four projections
at the bottom of the IC socket, and fasten it to the user
system.
Use the guide pins provided with the product to determine where to install the IC socket, as shown
in figure 2. When connecting the socket to the user system interface board, remove the guide pins.
4 projections to apply
epoxy resin adhesive to
Bottom view of IC socket
Rev. 3.00 Sep. 08, 2008 Page 4 of 30
REJ10J1870-0300
CAUTION
User system
Figure 2 Correctly Placing the IC Socket
Guide pins
Pin 1
IC socket
(NQPACK120SE-ND manufactured
by Tokyo Eletech Corporation)