Power Input - Extron electronics DVI DL 201 Tx User Manual

Dual link dvi transmitter and receiver
Hide thumbs Also See for DVI DL 201 Tx:
Table of Contents

Advertisement

Power Input

1.
Connect the captive screw connector from the supplied 12 VDC power supply into the
power receptacle.
CAUTION: Always use a power supply supplied by or specified by Extron. Use
Twisted pair cable 2, pin 5 carries a 12 VDC power signal. This remote powering
feature allows a single power supply, connected to the transmitter, to power both the
transmitter and receiver.
CAUTION: Power supply voltage polarity is critical. Incorrect voltage polarity
POWER
12V
0.4A MAX
Figure 6.
NOTE:
2.
Connect the AC power cord of the power supply unit to a 110 or 220 VAC electrical
source.
3.
When the transmitter or receiver is getting power, either directly from the power
supply or indirectly through the remote powering feature (receiver), the front panel
LED lights amber.
of an unauthorized power supply voids all regulatory compliance
certification and may cause damage to the supply and the end
product.
Unless otherwise stated, the AC/DC adapters are not suitable for
use in air handling spaces or in wall cavities. The power supply is
to be located within the same vicinity as the Extron A/V processing
equipment in an ordinary location, Pollution Degree 2, secured to the
equipment rack within the dedicated closet, podium or desk.
The installation must always be in accordance with the applicable
provisions of National Electrical Code ANSI/NFPA 70, article 75 and the
Canadian Electrical Code part 1, section 16. The power supply shall
not be permanently fixed to building structure or similar structure.
can damage the power supply, the transmitter, and/or the receiver.
Identify the ground ( ) lead by the ridges on the side of the cord (see
the figure below).
Power Receptacle
DC Power Cord
Captive Screw Connector
Ground
+12 VDC
AC Power Cord
Connecting Power to DVI DL 201 Tx/Rx
See the
second note
on page 10 for important information about wiring
captive screw connectors.
Smooth
Ridges
A
A
Power Supply
Output Cord
External
Power Supply
(12 VDC, 1 A )
DVI DL 201 Tx/Rx • Panels and Cabling
SECTION A–A
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvi dl 201 rx

Table of Contents