Installation Checklist
Determine which source will be used for the EDID information and configure the DDC
Prepare twisted pair cables ( see
Connect the transmitter to the receiver ( see
Connect the source device to the transmitter ( see
Connect the display device to the receiver ( see
If required, connect any RS-232 or IR control devices ( see
Connect the power supply to the transmitter ( see
Power on the display device.
Power on and boot up the source device.
Extron USA - West
Extron USA - East
Headquarters
+800.633.9876
+800.633.9876
Inside USA/Canada Only
Inside USA/Canada Only
+1.714.491.1500
+1.919.863.1794
+1.714.491.1517 FAX
+1.919.863.1797 FAX
switches appropriately ( see
store information from a display ( see
source device at this time.
monitor to the transmitter.
CAUTION: Read all the Cautions in the
Extron Europe
Extron Asia
+800.7339.8766
+800.3987.6673
Inside Asia Only
Inside Europe Only
+65.6383.4400
+31.33.453.4040
+65.6383.4664 FAX
+31.33.453.4050 FAX
©
2010 Extron Electronics All rights reserved.
. If necessary, use the EDID Minder to read and
pages 13 to 16)
).
pages 13 to 14
"Terminating shielded cable"
"Connections"
"DVI-D input"
"DVI-D output"
"Power input"
"Power Input"
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
www.extron.com
).
)
). Do not power on the
). If required, connect a local
).
"Control pass-through"
).
section.
Extron China
Extron Middle East
+971.4.2991800
+400.883.1568
+971.4.2991880 FAX
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX