Table of Contents
Advertisement
6.
7.
Setup and Operation
1.
2.
3.
4.
5.
6.
7.
8.
9.
Boot up the source device. The source boots with the resolution and refresh rate of
the remote display.
NOTE:
Because the remote display is the source of EDID, it must be powered on
before the source device is booted.
Power on the local monitor, if required.
NOTE:
The remote display device must be capable of handling a resolution equal
to or greater than that of the local monitor.
Determine which source will be used for the EDID information and configure the DDC
switches appropriately (see
and store information from a display (see
Prepare twisted pair cables (see
Connect the transmitter to the receiver (see "Connections")
Connect the source device to the transmitter (see
the source device at this time.
Connect the display device to the receiver (see
a local monitor to the transmitter.
If required, connect any RS-232 or IR control devices (see
Connect the power supply to the transmitter (see
CAUTION: Read all the Cautions in the "Power Input" section.
Power on the display device.
Power on and boot up the source device.
pages 13 to
16). If necessary, use the EDID Minder to read
pages 13 to
"Terminating shielded
"DVI-D
"DVI-D
"Power
DVI DL 201 Tx/Rx • Configuration and Operation
14).
cable").
input"). Do not power on
output"). If required, connect
"Control
pass-through").
input").
16
Advertisement
Table of Contents
