Physical Installation - Emerson 1410 A/B Quick Start Manual

May 2018
4.0

Physical installation

4.1 Emerson 1410A/B and 1410D mounting
The unit can be snapped onto a DIN TS35/7.5 or TS35/15 rail system. To clip the
unit onto the DIN rail, see
1. Tilt the unit at a slight angle allowing the lower lip of the chassis to catch the
bottom of the DIN rail.
2. Apply pressure forward to snap the back of the unit securely onto the DIN
rail.
Figure 7. Installing
To remove the unit, see
1. Place a flat or rounded object (such as a screw driver) into the DIN clip and
apply a slight pressure downwards on the object.
2. Once the unit is released from the DIN rail, pull backwards and down to
successfully disengage.
Figure 7.
Figure 8.
Quick Start Guide
11