Emerson 1410 A/B Quick Start Manual page 12

Quick Start Guide
Figure 8. Removing
NOTICE
When mounting the unit in an electrical enclosure or other location, comply with the appropriate local and
national installation codes. Verify that the installer, associated hardware, and installation equipment used have
the proper certifications for the specific type of installation being performed. Before installation, verify if local
codes require a permit and/or an inspection before energizing. When planning the installation, account for
routing the antenna cable within the enclosure.
Note
Do not mount the antenna within a metal enclosure. To avoid damage to sensitive RF
components, do not remove protective cap from the Gateway SMA connector until ready
to install the antenna.
4.2 Connecting the Emerson 1410D with 781
There are two main connection configurations for the Emerson 1410D and 781:
with and without barriers. The location and hazardous approval option of the
Emerson 781 determines whether it needs to be installed with barriers.
12
May 2018