Emerson 1410 A/B Quick Start Manual page 4

Quick Start Guide
3.1 Powering the Gateway
For both Emerson Wireless 1410A/B and the 1410D, bench top power will be
needed to power the Gateway by wiring a 10.5–30 VDC (20–30 VDC if a 781 is
connected with I.S. barriers to the Emerson 1410D) power source, with a
capacity of at least 250 mA to the power terminals.
Figure 1. Emerson 1410A/B Gateway Housing
Power
Reset
A. DIN Rail clip
B. SMA to N type connection
C. Power light. During normal operation the power indicator will be green.
D. Ethernet port 2. When this port is activated, the factory IP address is 192.168.2.10. See
Table 1 on page
E. Ethernet port 1. Use for standard communication to the webserver or other protocols
enabled on the Gateway. The factory IP address is 192.168.1.10. See
F. Emerson 1410 power and serial connection. Black terminal included in the box.
4
A
B
C
D
24 VDC
(nominal)
E
Power Input
+ -
F
9.
Serial
Modbus
A+ B-
S
May 2018
Table 1 on page 9.