Physical Installation - Emerson 1410H Quick Start Manual

February 2019
4

Physical installation

4.1 Emerson 1410H mounting
The unit can be snapped onto a DIN TS35/7.5 or TS35/15 rail system. To clip
the unit onto the DIN rail, see
Procedure
1. Push the DIN rail lever downwards so the spring compresses, and hold.
2. While holding the lever downwards, place the Gateway so it rests the
top lip of the bigger chassis on the DIN rail.
3. Release the DIN rail lever, and make sure the Gateway is secured.
Figure 4-1: Installing the Emerson 1410H
4. To remove the unit, press the DIN rail lever, and hold while pulling the
bottom half of the Gateway from the DIN rail.
5. Release the lever, and lift the Gateway away from the DIN rail.
6. To remove the unit, press the DIN rail lever, and hold while pulling the
bottom half of the gateway form the DIN rail.
7. Release the lever, and lift the Gateway away from the DIN rail.
NOTICE
When mounting the unit in an electrical enclosure or other location,
comply with the appropriate local and national installation codes.
Verify that the installer, associated hardware, and installation
equipment used have the proper certifications for the specific type of
installation being performed. Before installation, verify if local codes
require a permit and/or an inspection before energizing. When
planning the installation, account for routing the antenna cable within
the enclosure.
Quick Start Guide
Figure 4-1.
Quick Start Guide
13