Table of Contents
Advertisement
9.0 OPENER TUNING (LATCH & BACK CHECK ADJUSTMENT)
Latch Position
With door at closed position, set Proximity Magnet to activate LATCH. This will begin Closing Low Speed or Latch for 10 degrees of
travel, prior to door reaching full closed position.
Back Check Position
With door at full open position, set Proximity Magnet to activate BACK CHECK. This will begin Open Low Speed or Back Check for 10
degrees of travel, prior to door reaching full open position.
Adjustment
Setting Latch and Back Check position can be achieved using a small flat head screwdriver:
1.
Set latch check Upper Magnet over the reed switch at full CLOSED.
2.
Open door to full OPEN (90 degrees).
3.
Set Back Check Lower Magnet, while holding Latch magnet in place.
Latch and Back Check Proximity Switches are clearly indicated as shown by the sticker attached to the motor gearbox below.
TIP: At Latch and Back Check – Door should slow for the final 10 degrees of open or close movement. Back Check and Latch speed
adjustment may be necessary via control panel. (LED 1/2 – 0~5 in 6 steps)
WARNING: Proximity Switch MUST engage at open or close, otherwise door will not operate correctly and power fuse may be blown
(overload).
Page 16 of 31
WebDoor
info@webdoor.com
www.webdoor.com
Issued Date: 2017-03-28
Advertisement
Table of Contents
