Table of Contents
Advertisement
The pull-arm installation steps are provided in the table below.
Step 1
Open the door to full open.
Set three-position switch to Hold Open (II). The drive
shaft (spindle) will turn fully until hitting the internal
doorstop.
Step 2
Fit slide arm to the drive shaft (spindle) at the full open
position and tighten. Mark open position where roller
touches door.
Step 3
a.
Set three-position switch to manual (0) and
allow door to close under spring pressure.
b.
In closed position, place mark where roller
touches door.
Step 4
a. Fit slide track in line with 1
the door. Turn three-position switch to automatic
(I).
b. Test and adjust if necessary.
8.3 Pull Arm Installation
st
and 2
nd
mark and fix to
Page 15 of 31
WebDoor
info@webdoor.com
www.webdoor.com
Issued Date: 2017-03-28
Advertisement
Table of Contents
