Table of Contents
Advertisement
The push-arm installation steps are provided in the table below.
Step 1
a.
With door in the closed position, install door
shoe 14 inches from hinge side and 2 ¼ inches
from top of door.
b.
Attached rod to door block. Fit cast arm and
sleeve on drive shaft at 80 degrees to the door
latch.
Step 2
a.
Line up rod with sleeve and mark 1 inch past
2nd set screw and cut.
b.
Remove cast arm from drive shaft and insert
rod fully into sleeve. Tighten set screws.
Step 3
a.
With arm now fully assembled and fixed to the
door (by door-shoe only), set three-position
switch to Hold Open (=). Allow the drive shaft
to turn fully until hitting the built-in door stop.
Step 3
b.
Fit cast arm assembly to the drive shaft at the
full open position and tighten. If needed, loosen
set screws for minor adjustment of door
position.
Step 4
Set three-position switch to Automatic (-) and
allow door to close under spring pressure. Test and
adjust if necessary.
Page 14 of 31
WebDoor
info@webdoor.com
www.webdoor.com
Issued Date: 2017-03-28
Advertisement
Table of Contents
