Table of Contents
Advertisement
Push Installation
6.2.1 Changing Left Hand To Right Hand Installation
Steps
1.
Invert the entire opener assembly 180 degrees.
2.
Remove drive shaft (spindle) from motor gear box assembly (See changing position of drive shaft).
3.
Re-attach drive shaft (spindle) to opposite side of motor gearbox assembly.
4.
Detach wire connections from opener to control board.
5.
Remove control assembly from the base and rotate 180 degrees.
6.
Replace control and socket screws.
7.
Connect wire harness (see wiring).
8.
Fully tighten all bolts.
9.
Insert spline shaft on the opener (depended on push or pull application and spindle rotation)
Left Hand Installation
(Label is down facing the floor)
6.2 Opener Layout and Handing
Page 10 of 31
WebDoor
info@webdoor.com
www.webdoor.com
Issued Date: 2017-03-28
Pull Installation
Right Hand Installation
(Label is up facing the ceiling)
Advertisement
Table of Contents
