4 Disassembly and Assembly
4-2 Disassembling the Case Lower Block
4-2 A. Ass'y Printer
1. Separate the two harnesses(
2. Remove the four screws(E1,E2) from the PMO-CASE LOWER(E30).(Page6-13)
3. Separate the ASS'Y PRINTER(C) from the ASS'Y CASE LOWER(E). (Page6-13)
4-2 B. Ass'y Main PBA, I/F PBA
1. Separate the fourteen harnesses(
screws(E3). Lift up the PBA-MAIN BOARD(E4).(Page6-13)
2. Separate the harness( ) from the PBA-I/F BOARD(E21). (Page6-13)
3. Lift up the PBA-I/F BOARD(E21).(Page6-13)
4-2 C. Ass'y Adapter
1. Separate the harness( ) from the PBA-MAIN BOARD(E4). (Page6-13)
2. Remove the two screws(E15) from the IPR-BRKT TRANS(E25). (Page6-13)
3. Separate the PMO-HOLDER ADAPTER(E16) from the PMO-CASE LOWER(E30).(Page6-13)
4. Separate the harness( ) and Remove the ADAPTER(E16). (Page6-13)
4-2
) from the PBA-MAIN BOARD(E4). (Page6-13)
) and remove the three
SAM4S NR-500 SERIES