Sam4s NR-500R Service Manual page 31

3. Press the key and the
7.PROGRAM BACKUP menu.
4. Select the 1.SD menu.
5. Select the 7.BOOT UP COM menu.
At the PC, execute the program "DownLoad.exe". The Download dialog box displays.
7. Select the appropriate com port connection at your PC at the PORT# option buttons.
8. Click find the folder where the update files are located and select binary file.
9. Select Boot Area Only in the Select One option buttons.
10. Press OK Button. The download takes about 30 seconds; the scroll bar will track the progress of the
download. At the ECR, the display will flash slowly while the update is taking place.
11. When complete, the message Completed displays on the PC. Click OK and the Download program will
close. At the ECR, the display will change to a blue color indicating the update is complete. Turn the
power switch to the OFF.
Program Area Update
1. Connect the Serial Cable From ECR to PC.
2. At the register, move to the SERVICE MODE.
3. Turn the power switch to the OFF position.
4. Press the upper right key and the lower right key. A rapid beep-beep-beep sound will be heard. Release
the upper right key and the lower right key.
5. Press the key and the
1.SERIAL1 menu.
6. At the PC, execute the program "Download.exe". The Download dialog box displays.
7. Select the appropriate com port connection at your PC at the PORT# option buttons.
8. Click find the folder where the update files are located and select binary file.
9. Select Program code + Font in the Select One option buttons.
10. Press OK Button. The download takes about 3 minutes. At the PC, the scroll bar will track the progress
of the download. At the ECR, The display will flash (Current program is being erased), after a few
seconds, the display will continue to flash, but at a slower rate. This continues for about 3 minutes while
the new program is being loaded.
11. When complete, the message Completed displays at the PC. Click OK and the Download program will
close. At the ECR, when the load is complete, a rapid beep-beep-beep will be heard, and the display will
flash rapidly. Turn the power switch to OFF, the program update is complete.
12. Disconnect the PC cable.
SAM4S NR-500 SERIES
key to select menu and press the CASH key to confirm. Select the
key to select menu and press the CASH key to confirm. Select the
3 Installation and Operation
3-13