General Safety Summary - Tektronix WVR7000 Quick Start User Manual

General Safety Summary

Review the following safety precautions to avoid injury and prevent damage to this product or any products connected to it.
To avoid potential hazards, use this product only as specified.
Only qualified personnel should perform service procedures.
While using this product, you may need to access other parts of a larger system. Read the safety sections of the other
component manuals for warnings and cautions related to operating the system.
To Avoid Fire or Personal Injury
Use Proper Power Cord.
Connect and Disconnect Properly.
probe to the circuit under test. Connect the probe reference lead to the circuit under test before connecting the probe
input. Disconnect the probe input and the probe reference lead from the circuit under test before disconnecting the probe
from the measurement instrument.
Ground the Product.
shock, the grounding conductor must be connected to earth ground. Before making connections to the input or output
terminals of the product, ensure that the product is properly grounded.
Observe All Terminal Ratings.
the product manual for further ratings information before making connections to the product.
Do not apply a potential to any terminal, including the common terminal, that exceeds the maximum rating of that terminal.
Power Disconnect.
must remain accessible to the user at all times.
Do Not Operate Without Covers.
Do Not Operate With Suspected Failures.
qualified service personnel.
Avoid Exposed Circuitry.
Use Proper Fuse.
Do Not Operate in Wet/Damp Conditions.
Do Not Operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
Provide Proper Ventilation.
proper ventilation.
WVR6100, WVR7000, and WVR7100 Waveform Rasterizers Quick Start User Manual
Use only the power cord specified for this product and certified for the country of use.
Connect the probe output to the measurement instrument before connecting the
This product is grounded through the grounding conductor of the power cord. To avoid electric
To avoid fire or shock hazard, observe all ratings and markings on the product. Consult
The power cord disconnects the product from the power source. Do not block the power cord; it
Do not operate this product with covers or panels removed.
If you suspect that there is damage to this product, have it inspected by
Do not touch exposed connections and components when power is present.
Use only the fuse type and rating specified for this product.
Refer to the manual's installation instructions for details on installing the product so it has
General Safety Summary
v