Lenovo ThinkStation P920 Hardware Maintenance Manual page 204

3. Press the pit on the cover of the storage drive bay so that the cover is opened. Then, pull the cover edge
as shown to remove the storage drive bracket from the storage drive bay.
Figure 171. Removing the storage drive bracket
4. Lay the computer on its side for easier access to the blind-connect assembly.
5. To remove a blind-connect assembly, do the following:
a. Record the cable routing and cable connections, and then disconnect the cables of the blind-
connect assembly from the system board or the RAID adapter.
b. Press and hold the metal retainer
the four tabs.
Figure 172. Removing the blind-connect assembly
c. Pull the blind-connect assembly out of the chassis and remove the cables through the routing holes.
196
P920 Hardware Maintenance Manual
a , and slide the blind-connect board as shown to release it from