Lenovo ThinkStation P920 Hardware Maintenance Manual page 197

4. Lift the clip on the side of the flex module upward. Then, slide the flex module cover to the rear of the
flex module to remove the cover.
Figure 157. Removing the flex module cover
5. To remove an eSATA connector or IEEE 1394 connector, do the following:
a. Press the two clips toward each other as shown to pull the eSATA connector or IEEE 1394 connector
out of the flex module.
Figure 158. Removing the eSATA connector or IEEE 1394 connector in the flex module
6. To install an eSATA connector or IEEE 1394 connector, do the following:
a. Note the orientation of the eSATA connector or IEEE 1394 connector and route the eSATA connector
or IEEE 1394 connector cable into the cable clip.
.
Chapter 9 Hardware removal and installation
189